Header banner
Revain logoHome Page
🔧 versatile 4shank×3 1 grinded milling slotting tool for precision machining logo

🔧 Versatile 4SHANK×3 1 Grinded Milling Slotting Tool for Precision Machining Review

3

·

Average

Revainrating 3.5 out of 5  
Rating 
3.7
🔧 Milling Accessories, 🔪 Cutting Tools

View on AmazonView on ЯM

Media

(2)
img 1 attached to 🔧 Versatile 4SHANK×3 1 Grinded Milling Slotting Tool for Precision Machining
img 2 attached to 🔧 Versatile 4SHANK×3 1 Grinded Milling Slotting Tool for Precision Machining

Description of 🔧 Versatile 4SHANK×3 1 Grinded Milling Slotting Tool for Precision Machining

4 Flute,Cutting diameter=1/4'',Shank diameter=1/4'',Flutes length=1-1/4'',Overall Length=3-1/16''. Material:M2AI,High Speed Steel,long tool life.Extra long blade for deep cavity machining. Suitable for aluminium,cast iron,copper,magnesium alioy,plastics,wood etc(under HRC32(HRA66)). Full grinded,4 Flute,high abrasion resistance,obtain accuracy and fine finish. Package:1pc×end mill cutter.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    2
  • 2
    0
  • 1
    0

Type of review

Revainrating 3 out of 5

A little more chatter but still a good price

It's definitely an expensive alternative but it's less stiff than others I've bought. I need less vibration, but despite lots of feed, speed and depth of cut adjustments, I couldn't get rid of the vibration marks.

Pros
  • Quality construction
Cons
  • I don't remember but there was something

Revainrating 5 out of 5

Lightly milled stainless steel

I used this to mill 38° holes in ½" and ⅜" steel. Drilled a total of 40 holes with no problems. After that I was just curious to see how it would work with stainless steel, so I drilled a hole right through the ⅜ inch stainless steel with no chipping or drill breakage. Of course I used Kool Mist coolant. sharp and chip free Needless to say I am very impressed with this racquet and did not expect such quality for the price.

Pros
  • Delivery was very quick
Cons
  • Some mistakes

Revainrating 3 out of 5

So the best square nosed end mill

I thought it would be nice to get a Wokesi 1/4" x 3-1/16" end mill to get my 80% down, instead of using the expensive 4" cutter that comes with my jig. My plan was to use this shorter and cheaper end mill for most of my routing work and then switch to a 4" end mill to finish the job ...but after just one cut this end mill dulled so visibly that when milling the second receiver the milling became noticeably slower and rougher and I was spending extra time on each pass.. So while these end mills…

Pros
  • Lots of positive vibes
Cons
  • A little wrinkled