Accusize Industrial Tools Indexable End Mill - 3 Pcs Tpg32 Carbide Inserts, 1-1/2'' Cutting Diameter, 3/4'' Shank - 0046-0913 Review

The inserts supplied are not the best but they all installed correctly. Gives an excellent surface finish. would be again

Good quality tool holder, little wear but the inserts were torn off leaving two cutting edges instead of three. I would give 5 stars if it wasn't so. t for that.

TPG insert seats are set back by approximately 0.003. this means that it only cuts with one insert. Unfortunately I already have my TTS adapter installed on the stock so I can't return it. However, I was able to re-render the set and increase the inset. now I'm about 0.0005 off.

I did it like this to cut stainless steel. It can withstand high temperatures as it has carbide inserts. I didn't like how she acted when cutting the sides of the inserts. much chatter. I is good for flat passes and has a good finish. However, a hard metal insert has already flaked off a bit.

I have never used a flycatcher or end mill larger than 1/2 inch. This Accusize end mill gives me a whole new way to efficiently machine large areas without having to sharpen The flypaper attachment. The first test cut with the tool resulted in a high gloss finish that exceeded my expectations. The only downside to the purchase was the Inserts that came with the tool. The inserts are not standard TPG inserts. They have a flat rim to the rounded tip and the entire cutting edge is beveled at the…