🔧 Enhance Precision and Convenience with KREG ACS445 Adaptive Cutting System Guide Track Connectors Review

Holds together very well. The only problem I have is that it's a bit unwieldy with my large hands, I'm not sure if anyone else has the same problem.

I used them to connect two basic Accu-Cut systems, nobody had the XL version in service and I needed it that day. Keegan will tell you it doesn't work, but it worked for me.

As another reviewer said, it's terrible quality and a real disappointment. Bent out of the box and turned inside out. At 39.00 you would expect them to be at least straight considering they are just pieces of metal. I suspect almost anyone could do things better than this.

Product design keeps chains tight and level without creating localized stresses that could damage each chain. If you're using a rail saw to cut plywood, the only question is when do you need multiple rails and these connectors. I have compared my Kreg ACS chains to Festool and Makita chains and they are not compatible.

The manufacturer has very poor quality control on this item. Very disappointed in Craig. It took 5 or 6 tries to get it right. Twice through Revain and then I went straight to Kreg and they even sent me with my chains bent. The bad thing was that not only were they bent in length, but they weren't cut to the same width, so some of them didn't fit in the track. The penultimate set I received I was working on because I had a project to complete, up to 30 minutes to get them right. Craig acted…