🔋 Akozon 10S BMS PCB Protection Board with Balance, Heat Dink for 18650 Li-ion Battery Cell: 35A 36V- Enhanced SEO-friendly Variation Review

【Scope of application】The 35A 36V 10S BMS PCB Protection Board is suitable for 10-cell lithium-ion batteries, such as ternary batteries, manganic batteries and cobalt acid batteriesbms 36v 10s. 【Excellent performance】The charging and discharging interfaces are the same. With balanced heat sink and 10 low internal resistance high power MOS. The continuous discharge current is 35A. Instantaneous discharge current is 100A. It has a balancing function that ensures that each battery unit is fully charged at the same time. 【Unique design】wiring is neat, avoiding right-angled lines and curveing the edges; reduce signal vias to avoid signal distortion and cross interference; the wiring identifications clear and easy to understand avoid misconnection. 【Necessity】The material characteristics of the lithium battery make it impossible to overcharge, over discharge, overcurrent, etc. during use, so choosing the right protection board and applying it properly is critical to the battery life.This protection board provides stable various charging and discharging protection functions such as overcharge protection, overdischarge protection, overcurrent protection and short circuit protection. 【Note】Before installing the protection board, the batteries must be matched well. The better the battery consistency is, the farther the running distance is, the best performance of the protection board is; the battery should be connected in parallel and then in series.Make sure the welding is correct (18650 battery with nickel spot welding, other batteries with solder welding), do not use screws to avoid burning the IC of the protection board.