ASONPAO G3T-BX G3T-R Intellicode 3-Button 315/390MHZ Remote (2Pack) 🚪 for Genie Garage Door Openers - Ultimate Convenience and Control Review

Nice ruler that is easy to install for garage doors. I'm still trying to put up my security fence to keep the protesters out.

They were easy to install with my garage door and worked great the first time. They are small and do not take up the entire visor. i would buy again

When I programmed to stand directly at the door, but it opens with a delay of a few seconds after pressing the several times Button Will definitely be sent the back

Value for money is excellent but a bit annoying as it takes a second or more from pressing the button to the flashing of the red light and sending the open command to the opener. Next time I'd probably pay a little more for a better opener, but they work!

Works exactly like the original. I was skeptical at first, but sent it. I didn't want to spend 25-30€ for one. Both arrived. All materials are reminiscent of the original Genie. Works just like the original. It's worth it. This review was not paid for either. So buy, save money and get two for less than one for the same item.

They were pretty easy to set up. The problem was that they didn't work every time. I thought it was because I was too far from the garage door (second car in the back) but sometimes when stopped in front of the gate it didn't work. And just when I thought I'd have to send them back, they started working. I had to send them back because I needed a garage door opener that always worked.

Bought because we bought a new house and the seller lost the original remote. I just pressed the learn button on the garage door opener and double clicked the remote and it worked. The only downside I see is its inconsistency when stopping on my driveway. It takes a few tries to open the garage door and basically you have to be very close to the garage for it to work better. All in all, these are good backups when needed.

We really liked them. We had to replace four remote controls with two. Just be sure to clear the garage door motor memory before you start programming new devices. Our engine only eliminated up to seven codes, so we had to delete the old ones, which wasn't a problem because they were all replaced before we programmed the new ones. After that everything worked like clockwork. There is a slight delay when the button is pressed, but they work every time.

I programmed both remotes very easily, or so I thought. I needed both remotes to work at the same time because I need 1 of 2 different cars. I found that I could only get 1 remote to work at a time. When I program the 2nd, the 1st remote control no longer works and vice versa. Also, I have a 2010 car with a Home Link door entry system and programming either remote disables the system. So I can't use it with Home Link in my car. Unfortunately I will have to send them back and order a more…