Header banner
Revain logoHome Page
allstar performance all26087 cleaner spacer logo

Allstar Performance ALL26087 Cleaner Spacer Review

4

·

Poor

Revainrating 3 out of 5  
Rating 
2.8
🚀 Engines & Engine Parts, 🏎️ Performance Car Parts & Accessories

View on AmazonView on ЯM

Media

(1)
img 1 attached to Allstar Performance ALL26087 Cleaner Spacer

Description of Allstar Performance ALL26087 Cleaner Spacer

Package Dimensions: 20.32 L x 27.94 W x 4.318 H (centimetres). Country of Origin : United States. Package Weight: 1.15 pounds. Fit type: Vehicle Specific.

Reviews

Global ratings 4
  • 5
    0
  • 4
    0
  • 3
    3
  • 2
    1
  • 1
    0

Type of review

Revainrating 3 out of 5

Works great in engines and engine parts

Used for 4BBL Carter AFB. I had to cut out a small portion of the pitch to reveal the carb body, but this is a great replacement for the plastic spacer.

Pros
  • Lots of positive emotions
Cons
  • Thoughtlessness

Revainrating 3 out of 5

Sloppy fit over 4.3 TBI with stock air filter

This riser will not center the stock air filter when placed between it and the carburetor/throttle body. I stopped using it after trying to get it to work. He ended up in a garbage can. Maybe an aftermarket cleaner would be better.

Pros
  • Dope 🔥
Cons
  • Miscellaneous Miscellaneous

Revainrating 2 out of 5

Didn't fit! I use Eldebrock air cleaner base.

Didn't fit! I am using an Eldebrock air cleaner base, not a chip, the receiving groove machined into the adapter (ID) is the same as that of the air cleaner base. = does not fit in the groove! I'm going to make an adapter ring to use it, but if I knew I had to do it I would do the whole thing. If you are charging $15 for a 1 inch piece of aluminum tubing, please provide the exact measurements.

Pros
  • Decent performance
Cons
  • Not bad, but...

Revainrating 3 out of 5

But it works. in Air Filter Housings

It's not an iota polished. You can shine with a little oil on your elbow but not what I expected. I have used it on a Motorcraft 2150 and it fits VERY snugly. I use a rubber mallet to fully install it and a small pry bar to remove it. I also had to undercut the inside a bit because I was interfering with the throttle connector on the throttle body. It also doesn't have a lip to hold the air filter in place or center it, just an O-ring and friction. It works for the price and is better than…

Pros
  • Absolutely Amazing!
Cons
  • I vaguely remember