Enhance Your In-Car Control with Metra Axxess ASWC-1 Steering Wheel Control Interface Review

Follow instructions even soldered wires because online techs said it helps with resistance. Tony replied, I knew right away that he hated his job and didn't really want to help. with attitude. After he read the instructions to me and I confirmed that all the steps were followed correctly, we completed the programming steps. The lights flashed correctly, but when everything was ready nothing happened. We did this a few more times but to no avail. He then asked me to turn on the factory radio to…

I ordered this steering wheel controls with a new Pioneer double din radio for my 2005 Nissan Xterra. I installed it professionally at a very reputable shop near me, along with Apple CarPlay, an XM antenna and a backup camera. The steering wheel controls worked well when I was driving the car home and finished work later that evening. The next morning they were working without any tweaks or changes. This intermittent behavior continued for the next 3 days until I returned from an out of town…

Among the thousands of reviews, the search returns few answers on ATOTO, and they all say that the device does not work with this model. That is not right. I installed one today and it works fine. I used the ASWC-1 on a 2006 Honda CR-V. I connected to the wrong contact but their support helped me. The image in the ASWC document for a specific vehicle shows the wire harness from the wire side. Pin 3 in the top left corner of the harness is correct. For the ATOTO A6 you will need to use the jack…

I imagined the installation to be much more difficult. 2005 Silverado.with JVC stereo. It looks like a lot of work because there are about 12 wires. I think I only had to use 4. One for consistent performance. One for switched power supplies. One for the earth. And the one that goes to orange (for this model) I soldered to ground, 2 power wires and pink to orange (for Silverado). After that, connect the cable with the 3.5mm plug directly to the main unit. Their website tells you which…

A little confused. He wanted me to connect it to a blue wire with a red stripe. Spring. Apparently Ford likes the blue wires with the red stripes as there were 3 behind the radio. One was an unused pin on the factory speaker harness, the other I believe was the connector for the old rear seat audio panel, the last wire was connected through a wire harness that ran behind the radio to an unknown box behind the glove box. I assumed it wasn't the one who just passed the team. I first tried the…

aswc-1 is the best in the business. That said, there is no better steering wheel control harness that will work on so many cars and radios. There is no other kit (that I am aware of) that can be manually programmed to work with almost any radio. I was even able to get this to work on my Chinese Android radio Atoto A6 Pro. (no small task). For this reason I award 4 stars. If you have an obscure radio (or Chinese Android radio) then this is the cable set you need. auto aswc-1 works very well…

My regular Ford radio worked the same as the typical Ford radio, the LEDs didn't light up so it's time to replace it. I replaced it with a typical Chinese Android head unit. The typical Chinese head unit came with no instructions. Typical. So I searched the internet for a typical installation of Chinese head units on Android. I realized I needed an interface, so I bought a METRA AXTC-FD1 INTERFACE FOR WHEEL CONTROLS AND ACCESSORIES. Well, to my usual luck, that device didn't work, so I called…