🔧 Befenybay Upgraded ANYCUBIC Leveling Diameter Review

My Tevo tarantula doesn't fit. I thought the missing 5mm would be easy to adjust but my printer won't because of the brackets. If length isn't an issue, get them, they're more than good and better than waiting for delivery from China. Countersunk screws as of 02/21/2021. In my case, the springs are 5mm shorter, but I don't think it matters, I need to adjust the Z height, but it's faster than saving $3 and waiting for them from China.

I bought these to upgrade the wing nuts on my 3D printer and it turned out to be one of those small changes that can make a huge difference in print alignment . Bed. Not much to say other than that the quality is good, the nuts are comfortable and easy to adjust, the springs have just the right amount of tension, and the screw heads sit snugly on the top of the bed. I added hex nuts to the bolts where they go through the bed to hold them in place when adjusting the knobs, but that's not really…

My Anet A8 had to modify both the printer and the thumbscrews. A printer modification is required for such thumbscrews. I will explain this later in the review. I found the diameter of the thumb wheel was a bit big and got dirty on the printer body. I had to take the two front ones and use my bench sander to make them smaller. To change the printer: 1. I removed the old screw/wing nut assembly from the printer.2. Then I had to use a 1/8" drill bit to drill threaded holes in the slide. This…