Header banner
Revain logoHome Page
πŸ”₯ superior quality: bestgle titanium engraving for unmatched woodworking logo

πŸ”₯ Superior Quality: Bestgle Titanium Engraving for Unmatched Woodworking Review

3

Β·

Very good

Revainrating 4 out of 5Β Β 
RatingΒ 
4.0
πŸͺš Router Bits, πŸ”ͺ Cutting Tools

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ”₯ Superior Quality: Bestgle Titanium Engraving for Unmatched Woodworking
img 2 attached to πŸ”₯ Superior Quality: Bestgle Titanium Engraving for Unmatched Woodworking
img 3 attached to πŸ”₯ Superior Quality: Bestgle Titanium Engraving for Unmatched Woodworking
img 4 attached to πŸ”₯ Superior Quality: Bestgle Titanium Engraving for Unmatched Woodworking

Description of πŸ”₯ Superior Quality: Bestgle Titanium Engraving for Unmatched Woodworking

Made of high quality high speed steel for long life and exceptionally precise cuts the first time, saving you energy and stress. 10pcs Router Bits including straight, trim, V groove, beading, cove, slot cutter and more to meet your different needs. Easy to use - large capacity chip groove, and spiral cutting edge sharp, greatly enhance the efficiency and quality of products. Shank diameter: 3mm(1/8"), length: 38mm, easy to insert into most mini-grinding rotary tools including for Dremel, Craftsman, Chicago and more. Can be used for detailed woodworking, trimming, engraving, milling, routing slotting, this routing bit works on soft wood and metal including wood, ABS, acrylic, PVC, plastics, etc.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    0
  • 2
    1
  • 1
    0

Type of review

Revainrating 2 out of 5

Good size but breaks easily

They break on the shaft. I used 3 of them. One was enough for about 10 cuts. One was enough for 3 haircuts. One didn't go through the first cut and broke off. All of them were used in Rotozip.

Pros
  • Knife
Cons
  • old

Revainrating 5 out of 5

Works, does not warp or overheat

I used these to round the edges of 13 oak steps. I was concerned about the lack of a bearing, but on a dremel with a router base, the guide didn't burn out. The chisel was able to cut without bending the shank and performed as expected.

Pros
  • Edge and Groove Milling Cutter
Cons
  • Not sure

Revainrating 5 out of 5

The small keyhole is difficult to find.

I also bought this set exclusively for the keyhole tool. It's actually *almost* too much for what I need. With that in mind, here are the dimensions of the keyhole. large step cuts 7.95 mm or 5/16" wide and 4.1 mm or 5/32" deep. The small step is 4.55mm wide or 5/32 and the edge is 6.1mm deep or 15/64. (The last measurement is the least reliable, but also probably the least important.) I'm pretty sure I want to find a keyhole drill bit that's less than 1/4 inch at its widest point.

Pros
  • Power tool parts and accessories
Cons
  • No instructions