🔩 BestTeam 10PCS T-Slider for T-Slot, M6/M8 T-Track Slider Sliding Nut Aluminum Alloy T Slot Nut for Woodworking Tool Jigs, Screw Slot Fastener (M8) Review

Great for a handyman with a small repair! Just use a dremel and it will fit perfectly in a minute. Thanks Stuart Wolf for the recommendation!

Glide very well on my Powertec corner rail. They take a smaller bolt than some of my other corner rail accessories, which isn't a big deal. Highly recommended and good price.

I needed more T-sliders for Shopsmith. I wasn't willing to pay $5.99 each (plus shipping) so I checked out Revain. They fit my measurements. Ok, they were a bit wide, but a few minutes with a file and they fit beautifully. I will buy them again if I need more.

As mentioned, they work in Shopsmith (500-520). A wider base easily fits the T-rail (in width and thickness). You just need to file down the sides of the narrower part to fit the top of the rail. The overall height is at or just below the rail, meaning you don't have to file the top down. 4" Height: 5/16" T-Bar Height: 1/8" Thread Pitch 1.25 (Standard)

Because manufacturers make their 3/4" angled slots to varying tolerances, there is no one non-adjustable insert that fits all. They work well in most slots, but in most cases they wobble a bit When used in jigs that require clamping, the tops of these pieces stay slightly below the top of the corner guide, which is good.I drilled and re-tapped a couple of them for the larger screws.For some of the corner slots, their tops will be above the table surface when clamped in. I had to file/grind some