🚗 High-Quality BQLZR Momentary On/Off Reset Push Button Switch Black Pack of 6 for Car Boat Review

Be very specific about how long your soldering iron stays on the pins once it's plugged in or you'll have to reach for a new one. Luckily you have a few extras in your bag.

Great buttons with an amazingly smooth feel. Although they are blunt, they break easily. I wish they were a little stronger. I believe 3 of these broke although I was extremely careful and did my best to handle them with "caution".

Works well but I had to buy bigger ones with pre-wired cables. They are small, short and have small connectors so they are not easy to install. If you must buy these little ones, buy one with the wires pre-installed or attach a piece of wire to the connectors before screwing them into the dash.

very poor quality and I wouldn't trust them to be waterproof at all. If you need 2 or 3 switches that should be fine, but don't count on all 6 being fully functional. Some arrived with cracks on the back of the terminals, others were broken. The action also varies a lot, some feel decent, most don't. This is a cheap Chinese clone of a higher switch. .

I built my own hydraulic stop for a backhoe. It includes a 12 volt hydraulic switch. I pressed the momentary switch with my heal to toggle a control from bucket to thumb. I used a few starter buttons, each of which lasted a season, and then tried these. Instead of using screw terminals like starter or horn buttons, you need to solder wires to these switches. Because the terminals are small, very short lengths of fine wire are used to reduce resistance since the rest of the wiring is heavier…