🔒 Bull Ring Stainless Steel Flush Fit Retractable Tie-Down Anchors for 2009-18 & 2019-20 Dodge Ram Rear Holes Model 4066: Polished Stainless Cover Rail Cap with Alteration Requirement Review

Bought 2 sets for 2017 Dodge Rebel. I had to carefully trim the rear guide caps to clean this tie, using a utility knife to avoid cutting the paint. At the cutouts in the front rail cover I used the tape as a guide for cuts perpendicular to the length of the bed to minimize the cut hole to no more than a bullring. It's not necessary to cut the entire profile, leave about 1/4 inch from each end and leave a nice finished look when you're done. You must immediately use them with bungee mesh to…

I bought a 2017 Ram 1500 and needed something on the side rails to hold my tie down straps while buckling. My truck has one of these hard body covers, and the rails have covers as well. So if I needed to tie and hold something, I had to use the internal belt loops, which was cumbersome. So I looked to see what I could install on external rails. I found these ties for Bull Ring. Now I had to cut out the rail covers where the rail holes are, which took a bit of time to avoid cutting through the…

They look great and work well. No rattles. BUT, if you have a RAM 1500 Tradesman with a Mexican made long bed, make sure you pick the right ones, they aren't. The Bull Ring has a special model for the front holes in the NAFTA dealer's bed. When you receive these, they will be installed perfectly. If you don't do this, you will get into trouble. Call Bull Ring and they will explain the problem and what you need. By the way, their customer service is outstanding. You can talk to real people in…

A bit of work if you decide to use a shop knife to trim the plastic to fit. If you don't have much time to install, buy a bit kit sold by Bull Ring. I used a shop knife and it took about 10-15 minutes to cut each whole piece, cut a little with a trial fit, cut a little with a trial fit. Note: Just because your stake holes are already cut - they won't fall off easily, you'll need to trim back the sides and ends of the hole (plastic) to allow for the crome border on the bottom (see photo with the

This is my second set, I installed it on my 2007 Ram Laramie CC with an 8" bed almost 10 years ago. This setup was on the 2017 version of the same truck. Unlike the 2007 model, the 2017 model has an overlay on the bed rail. On my truck, the holes in the bed rail cover weren't as large as the floor post pockets (and they didn't line up). The Bull Ring's stainless steel top/cover is molded so that when installed, a portion of it is recessed into the cover and the top is flush with the surface of…