Cabinet Hardware Jig Punch Locator - Drill Guide Adjustable Inch & Metric Scales, Aluminum Alloy With Φ5Mm Drilling Hole, Tool Cabinet With Drill Bit And Hand Marking Tool Review

This jig was good for some basic home use. All in all not bad for the price. It does a good job at aligning but due to the materials used I wouldn't recommend using it professional or for very precise work. For occasional use it should be fine.Top Position:The top vertical positioner is has a metal ruler with plastic trim. While rigid is slightly flexible as is the whole unit in general. The set screw bear down on plastic which will deform and eventually will develop memory indentions of…

I like this item. I build the occasional chest of drawers and wardrobe. I found this to be very useful for making sure all my drawers had the same setup. You could also use this for drilling holes for adjustable level bookshelves though Kreg makes a better jig for that purpose. I found this to be easily adjustable I just with the metal rulers were longer for bigger pieces of furniture. You can always buy longer flat metal ruler on revain and modify this.The screws hold the template holes in…

While this Jig may come in handy for other situations its mainly designed as a jig to install cabinet and drawer hardware so that you can drill the holes in the exact same spot on each cabinet and drawer. The tool work great for this purpose, build quality is descent but the ruler part is a sticker which I wish was a metal plate or something to that nature, the sticker has already started to scrap off in one areaIf you have to install some cabinet hardware I highly recommend getting a tool like

This whole jig is functional, as advertised, for casual DIYers. But, I think it is likely not precise or durable enough for serious woodworking professionals.The plastic pieces are rough around edges, and they seem to be just regular plastic. Not the high quality hardened plastic that can stand up to more use & abuse. The included punch and the drill bit are both too small for the drilling guide.too much wiggling room for precision punching or drilling at dead center. The only saving grace is…

I have 12 kitchen draws to put new Soft close rails in. I did the first one but had to move the rear plate twice since I don't have a way of aligning it to the back wall of the cabinet.When I saw this I thought it would be perfect. However it only does the side rails onto the drawer itself. I don't need a guide for that. That's the simple part.Plus, when I was laying it out I noticed it was not 90 degrees. The plastic molding tool was broken and repaired several times. The ejector pins have…

I'll admit I'm not using this for its intended purpose. We have a couple VERY large mirrors that need to be hung and I'm not fan of the wire method. I want to hang them on individual screws using the attached mounting hardware on the mirrors. OF COURSE, no matter what you pay for a mirror and no matter what size it is, the mounting brackets in the back are NEVER level. One is always higher or lower than the other, making mounting this way impossible. I always wind up taking them off and…

The Voltstorm BraveX Cabinet Hardware Jig Punch Locator comes with 4 guide hole jigs, a drill bit and a marking tool. It also has a zip up carrying case. There are metric and imperial rulers on both rulers.A jig like this is useful for making repeatable measured holes for various things - front drawers, drawer sliders…really anything with a flat surface that you can line up from two sides.This jig has a lot of plastic parts - unfortunately in the key places where you need a solid 90’ angle. If…