🔧 Aluminum Alloy Cabinet Hardware Drill Guide Sleeve Template for Door Drawer Handle Knobs Pull Installation - Inch and Metric Review

Metal ruler and components work very well. I was able to drill 37 cupboard and drawer doors accurately and without errors. The mostly all-metal construction makes this tool durable and accurate. It looks like it will last for years. TIP: You don't need to keep a straightedge at zero (0), which allows you to drill holes for 128mm rods in drawers that are at least 24 inches wide.

We had a lot of cabinets that needed redoing so we went with this model because we thought the metal rulers and clips all projects would remain faithful. they remained faithful. That's why we chose this model. For metal and plastic parts. There are some plastic parts, but not where critical adjustments are made. Using one of these tools, measure 2 or 3 times before drilling.

Money well spent. We made about 100 cabinet pulls in less than 3 hours. The husband adjusted the doors and drawers by drilling holes. I came for him and installed the equipment. So easy and fast. The result was great! To the seller: The delivery was quicker than expected and without any problems. The lamp is well built and we will be using it in my brother's house. Also, my daughter says she wants to buy furniture for the house. Fabulous!

I am just finishing the renovation of the whole house. I used this to install appliances in a full kitchen and two bathrooms. It was exactly what I needed. All handles are straight and equal. I've worked with different sized cabinets and drawers, so I had to make adjustments as I worked. Just pay close attention and make sure the thumbscrews are tight as you go (I pinched them with pliers). The pilot holes in the tool are thick enough for your drill to go straight in and this helps a lot when…

I have remodeled all my cabinets and replaced handles with handles. They have more than 60 doors and drawers. Using the manual is the only way out and I'm sure I won't screw it up now. I read a lot of reviews and decided I needed metal not plastic. I carefully mark the holes with a small tap of the drill and remove the guide to pierce. That way I won't gnaw holes in the instructions until I've finished them all. A small price to pay for the precision required to evenly adjust the grips. My…

We bought a new vanity for bathroom renovation. The closet cost several thousand dollars, but without knobs and knobs. When it came time to install the tie rods, I didn't like the idea of marking and drilling holes. I was afraid I would make a very costly mistake. I found this tool and decided to try it. This tool was very easy to use and allowed all the holes to be drilled quickly and easily with far fewer opportunities for error. Within minutes all the holes were drilled and they were all…

We recently remodeled the kitchen we needed to add handles. I was appalled by this process and didn't know how to do it to make everything go smoothly. A friend recommended this remedy to me, I was afraid of it too! But no, it was very easy! I would advise you to use a ruler and accurately measure the distance from hole to hole on the cabinet handle. First check the handle and screws to make sure they are accurate. The tool made alignment much easier thanks to the guide rail. It's well made and