🔧 3x Carburetor Carb Rebuild Repair Kits and Float | Fit for Johnson Evinrude 396701 65 70 75 HP | Enhance Engine Performance Review

All the seals as expected. The only problem was that the brass calipers didn't screw in properly for everyone with the new conversion kits. I had to use the old seats.

Many parts do not fit. Only the float needle and two spacers fit. If you plan on changing your seat, be prepared to rev up the carburetor. It does not come with an outlet nozzle. Also, it's cheaper than going OEM.

I used these kits on a 3 cylinder OMC engine because my wholesale supplier didn't have them. The needle thread seats were too tight and the spacers were a different material than the Vinton sets I've always used. But I finished the job and the engine ran great.

This is junk. You don't save money in the long run. In three months you will be overhauling your carburetors again. Because the non-ethanol gas will corrode the seal and the floats will get stuck. Buy from an Evinrude/Johnson certified marina. Read other reviews. I should have taken the reviews as a warning.