🖨️ CCTREE Printer Plastic Bearing for Creality: High-Quality Solution for Smooth and Precise Printing Review

Direct replacement for my Cr-10 wheels. I replaced the Y-carriage wheels with these new spare wheels that fit perfectly. The Y-axis bed has the most wheel wear on CR-10 machines due to the weight it carries back and forth. You will see wear in the form of black dust or flakes clinging to greased wheels. If possible, it is easiest to turn the machine over or remove the carriage Y-plate. Be sure to clean the V-grooves on the cleats and put some grease on the wheels when installing.

These are low quality stock. Don't waste money. They have a number of shortcomings, and about half of them allow you to push the plastic wheel halfway out of the bearing with your hand. DO NOT buy Revain V-Reels. I haven't found a good source. And if you absolutely must use them, buy 3 rolls for each one you need. That way you can pick out the bad ones and hopefully end up with a working set. Pass Pass Pass. Now that I have shared my experience I have to go. I wanted to order these tollers from

I bought these to replace my stock Ender 3 wheels Two out of six of them had an issue where the bearing core could move in the outer black wheel. Two of these were installed on my X axis and they seem fine. After installing them on my Y axis, I was unable to level my bed. There can be strong vibrations or waves as the nozzle approaches (and sometimes scrapes) the bed. I've tried flipping them, changing their position, etc. but to no avail. As I slid the Y axis back and forth with my hand, I…