CNC Bicycle Shifter Cable and Housing 🚲 - Perfect for Road/Mountain Bike/MTB, Available in Multiple Colors Review

I used it on my 1995 Trek mountain bike with no problems. Becoming a cable cutter is highly recommended, which is very important for the job.

I had several cables with a drum on the end that was too big for my brake lever. These cables fit perfectly and I'm glad the clamps and grommets are also included. Very important.

Worked as it did on my Infinity Boss Three, Shimano 7 Speed RevoShift. I bought a bike from Costco. Although the courier left the package in the rain, it works perfectly.

Everything is fine, someone left a bad review about the length, probably because I tried to put the front on the back, I did the same at first. They are of different lengths, obviously the front ones are shorter. Worked great on my bike!

Fantastic and cheap as the red wire is clearly not a popular colour. I think any light color is great for making the bike more visible on the road. Good bits that you always need later come with a cable and case. A+

This is good, looks good but very deceptive. Can't comment on durability and will update later when color fades. The only way to get front and back is if your current case has exposed breakout wires. Otherwise, a full run to the rear derailleur will leave you with about a foot or so left.

The cable housing is not very flexible making it difficult to properly route the housing in the right place on the bike. It was cheap and I only needed a small amount of shell to build a Cannondale road bike, so I went with this shell. It's not nearly as flexible as the proprietary Jagwire case I usually use. I think you get what you pay for. I would recommend better accommodation for this.