🔴 Daystar Universal Rocker Switch with Red Light: 20 Amp, Single Pole, KU80014 - Made in America - Find the Best Deals! Review

Installed in a tarpaulin trailer as a "main" disconnect switch for battery power. I installed it on the side and I like the fact that it's easy to control and determine its status without seeing it. The light is pretty bright and obvious so I'm thinking of turning it off or seeing if it's on right away. Will be updated in case of problems in the future.

rocker switch perfect for Polaris Ranger. easy installation. I've used it several times since installing it and it looks like it's well made and will last. The time will show. Update August 11, 2014 Since installing this switch I have ridden many miles on the ranger and use the switch. Still runs like a champ. I have replaced two other cheaper switches but this Daystar has proven to be bulletproof!

Firstly, contrary to what it says, it doesn't match the Gen 4 4Runner so I had to cut out the tab on the dash to paste it. , the light uses the same power connection as the circuit being controlled, meaning you cannot use it to break the ground wire. I had to turn off the siren and access was only to the floor. I did this but the light doesn't work.

I used this to replace a broken switch in a two legged KAWELL® wiring harness including a switch kit to support the wiring harness and a 180w LED lighting switch. This switch was very easy to install (2012 RZR 570) as it fits perfectly into the pre-punched holes in the dash. It glows red when the off-road headlights are on and looks cool. (The glowing part is totally unnecessary as the LEDs are insanely bright. But it looks cool). Can't comment on how well it weathers as I haven't ridden in…

Winnebago View uses a switch that looks identical but has a slightly different connector on the back. I needed to replace the hood light on my RV and came across the following: In order for the Winnebago universal plug to fit the back of this model, I had to cut off some of the plastic on the new switch. Then it connected well; No need to crimp new connectors if you're okay with this little operation. Do not subtract stars for differences in part numbers; It was just the closest OEM I could…

Bezel Daystar JK: Fits just right, just right. Automatic transfer. The color fits too. Punched areas for cutouts can be easily cut out. INSTALLATION TIP -> I had to use a chainsaw file to smooth the edges/burrs of the derailleur holes for a very clean fit. It would be five stars if it came with its own set of clips. Switches: They switch properly, simply, directly, with a high enough rating to pass my accessories through without a relay. The lighted part of the switch works perfectly. My…