DB Link RTG0 Gold Ring Terminal: Efficient Wire Connection with Enhanced Conductivity Review

These are quite large, they hold up well and have a large Allen key to tighten. The nose is off-center for clearance. But I haven't used them, they are too big and because of the power you get you have a chance to ground them. Your body exposes a large metal surface. So I would recommend using heat shrink tubing over it after installation. But if you have no other way to install the terminals, then everything is fine. I prefer cheaper clamps and clamp them in a vise. I feel like theses are more

I used them to connect a car stereo amplifier. I went a little overboard with the wiring in case I decide to upgrade any components. I used this with 2 gauge wire. No adapter needs to be used. The set screw holds the wire in place very securely. On the other hand, they are nicely finished and hold the end of the cable very well with a hex screw. For use on the positive terminal of my battery, it fits well and looks better than the original equipment. On the other hand, finding a good ground…

I have purchased several DB Link cabled products and I am happy with the price. I'm very happy for that. They perfectly match the Monster Single aught (1/0) cable. Well, mine had very thick insulation - about 1/4 inch - but the wire itself fits perfectly. I had to trim the insulation a bit. Regular wire will probably fit just fine (there is a small space at the end where the insulation fits into the connector for a neat look). The set screw uses a large enough hex wrench so I was confident I…

These ring terminals are great for 0 gauge wire. The finish is beautiful, just like in the picture. The fuse holder had to be modified slightly, the cover didn't quite snap into place, but from a purely visual point of view it was worth it.

I chose these ring terminals because I can't solder. pulled really hard on it. The only thing I don't like is the thickness of the terminal. I had to connect 2 of these to the negative battery post and maneuver them around to make it work with my Xs Power D2400, but I was able to do it. Very good product. and I would recommend it to anyone who doesn't solder and wants a solid connection of 0AWG wires.

later These are quite large, they hold up well and have a large Allen key to tighten. The nose is off-center for clearance. But I haven't used them, they are too big and because of the power you get you have a chance to ground them. Your body exposes a large metal surface. So I would recommend using heat shrink tubing over it after installation. But if you have no other way to install the terminals, then everything is fine. I prefer cheaper clamps and clamp them in a vise. I feel like theses…

I used them to connect my car stereo amplifier. I've overdone the wiring a bit in case I decide to upgrade any components. I used this with 2 gauge wire. No adapter needs to be used. The set screw holds the wire in place very securely. On the other hand, they are nicely finished and hold the end of the cable very well with a hex screw. For use on the positive terminal of my battery, it fits well and looks better than the original equipment. On the other hand, finding a good ground point was a…