🔩 Dog River Tools Utility Trailer Stake Pocket: Bolt-On, Zinc Coated 2X4, Bottom for Flat Beds and Trucks - Pack of 4 Review

I used these for 2x4 bags on my utility trailer and after using them I bought a second set to finish the job. I would recommend them.

Still to be installed. However, I hope they work well. There is no reason why they should perform less than excellently.

They are zinc plated which will corrode over time. If they were galvanized I would give them a 5. Everything else about them deserves a 5.

Works great 👍 for my small utility trailer and I can easily detach and reattach the sides. The mounts are well made and appear to be of good quality with rounded corners. would recommend.

Although a little more than I was going to pay, they did a great job. Note, however, that the betting pocket size may not match the size of your bets. Had to crop the edited 2 x 4 to fit :(

Excellent product. 2x4 often don't do justice to 5 stars. I used them to build them into a bespoke tray by making removable guards around the edges. I colored them to match. I had to add a washer between the bracket and the tree as the fences were too tight to remove otherwise.

When I saw these I was ready to give them 5 stars. But when I went to install the 2x4 wheels, I found that without cutting, they wouldn't fit. Each had to be cut to fit the mount. It takes time and time is money. I'd rather have them bigger than smaller. I wouldn't buy them again.

I used these brackets to make bed rails in our camper van. They are sturdy and match a pretty good finish. The pocket feature (with a bottom for 2x4 storage) was key to my project and is hard to find among other products. The brackets are 6 inches wide and 2 inches high. The center of the square mounting cutouts are 1/2 inch from the outside edge. I used a 5/16 screw and washer, but the cutout is made to fit slightly larger. I would use them again for another project.