🔧 Dorman 306-010 Secondary Air Injection Pump - Top choice for specific models Review

Works great but doesn't come with pump impeller housing. So if your house has a crack like mine, you're in trouble. You cannot purchase the case separately. I needed to get my pump case working again, even though it was damaged. Otherwise I would have had to buy a brand new $450 pump from GM.

Ordered this for a friend of a 2006 Tacoma 2.7 with codes PO418 and PO2445. This worked great and fixed both codes. You will need a small torx bit to remove the old motor and install the new one. You can also disconnect the Toyota wiring harness from the old engine and connect it to the Dorman engine terminals. No soldering required. Even with Toyota, the black wire is power. White is earth. I swapped them in 1st and the pump sucked instead of blowing.

I had horrible codes P0418 and P2445 on my 2005 Lexus GX470 running on 2005 to present Toyota ULEV 4.7 engines in Tundra, Sequoia, LX470, GX470, V8, 4 sliders. Read online how not to use the Toyota/Lexus markup and replace a $400+ Toyota pump with a GM part and it worked beautifully. (This is the exact same pump, just take the old wiring harness off the old pump and put it on the new one. The part probably came from a regular dealer.) Thanks to co-owners at Tundra Solutions and the guys at Club

, I ordered this to repair the check engine light. The code told me it was the air pump system and as far as I could tell everyone recommended replacing the air pump. The air pump is electric and my car is over 10 years old (2000 Firebird formula). This product is only an electric motor and does not contain plastic pump housing. This was great as I saved money by not having to buy everything. I took out the old one, sat at the kitchen table, disassembled it and replaced the electric motor. Less

My secondary air pump was not working. I bought a 2002 GMC Sonoma about 2 months ago so I don't know how long the pump has been bad. Before replacing the pump, I changed everything on the secondary air injection system. I changed the hoses, pump relay, solenoid valve, solenoid valve, inlet pipe and check valve. After all that was replaced I checked the voltage and made sure the solenoid was working properly. I made sure the new check valve was working properly to prevent water from going back…