Heavy Duty Faucet Wrench 🔧 with Vinyl Grip - Draft Warehouse Standard Review

Works well for intended purpose. I like that the handle is covered in plastic or rubber because it doesn't cut my hand when I turn on the faucet.

the tooth is a bit flat so prone to slipping. I don't need it often so it's fine for me, but I wouldn't recommend it to anyone who needs this tool for everyday use.

Didn't know my faucet needed a special key, works great and allows for a thorough cleaning. I'll try to attach it to my mini fridge with a magnet.

The tooth on this wrench is virtually missing so it slips off when you try to tighten the faucet and you get frustrated and once the faucet opens you feel compelled to drink. because of said disappointment, and your beer will run out quicker, and everyone will lose.

The tooth on this wrench is virtually missing so when you try to tighten the tap it slips leaving you frustrated and once the tap is tight you feel forced drinking said frustration and your beer will run out faster and everyone will lose.

I immediately cut my finger on a metal burr in the handle. It protruded through a rubber grip. Upon closer inspection I noticed another burr on the working part of the tool where the tool makes contact with the hole of the nut being tightened. Poor workmanship and quality control. After removing the burrs I had to touch them up with a small file. Now it works fine.

Good quality metal and cap but unfortunately absolutely NOT suitable for standard faucet fittings. I tried trimming the plastic cover to see if it would fit better but it didn't work. (The wrench I received doesn't look like the photo, the plastic actually extends halfway down the wrench and covers the mating surface.) Listen to others. This does not fit or was sent incorrectly.

If you know what this is and are looking for this product, get it. I have 2 faucets that it works great on and can't foresee any problems. I throw mine in my beer fridge (I have 2 taps on the doors) to keep up with it. Others have expressed concern that the small protrusion broke but may have had a defective product. Most likely all specimens sold are MADE by the same manufacturer from the same material.