🔒 Smart NFC RFID Electronic Cabinet Lock with Slide Latch for Double Door Cabinet, Locker, Drawer, Wooden Cupboard - Hidden DIY Locks (Android Support) Review

It took 3 hours to try every conceivable configuration. As a result, the dresser was full of holes. And most of the screw heads are striped. Couldn't get it to work properly after many adjustments. save your money

These locks are great and best of all, they're hidden. I have a custom bar cabinet that I wanted locked and didn't want to see anything on my pretty cabinet doors. This did exactly what I wanted!

We like to lock the cabinet from the inside so nobody can see the locks, holes and stuff. Installation turned out to be a little more difficult than I expected as it was difficult to align both parts and the instructions were terrible. But after installing it is very cool.

This lock was difficult to install. The base of the lock and locking mechanism were misaligned and required shims to be installed for it to work. The instructions read as if they were written by a seven-year-old child. Once properly installed, it works most of the time. I can get two cards to work but not the key fob.

This RFID lock is working fine after I finally installed it. The cards are easy to code and work well through 3/4" plywood. The only issue I had was with installation. The instructions aren't very clear and the measurements just didn't work. It took a lot of trial and error to get the lock clicking properly without too much play After all is said and done, it works.

Love the idea of these locks and the fact that we can have locks for our kitchen cabinets without having to drill holes (we need chemicals, medicines, etc. locked to a foster family), but the key often requires multiple attempts to swipe it through the lock before reading it, which can be frustrating. I thought it might be out of order or defective, I've waited a while to post but I guess sometimes they just hit and miss. Overall, these are great locks and they get the job done, but only most…

Purchased to complete a two door wine cabinet. Found it easy enough to install. Had to use 2x4 to block the bottom to fit in the cabinet alcove but it was easy enough. The hardest part is the secondary lock. A push pin that was quite difficult to set at just the right distance for it to fully hook or miss. Otherwise it was a breeze. Programming got a little tricky to get two cards and a master fob working, but it only took a few minutes and a few tries. If you are good with tools and know some…

I bought two of these for cabinets. The defect of the first was that the locking piston got stuck and did not want to close. After requesting a replacement, the replacement worked as advertised. Installation was a little tricky trying to align the locking device with the locating pin. This would be easier with a template to align the two pieces when installing the cabinet. To work around this, 1. Measure the center of the pin to the base of the case. 2. Measure the side of the cabinet door to…