🖨️ ELEGOO ABS-like UV Curing Additive Manufacturing Printer Products Review

This resin is fantastic. I'm almost afraid to praise too much because it's well priced and will probably sell out lol. I use my Photon Mono and the details are sharp and the prints are quite strong and not brittle. For settings I use 4 base layers with a base exposure time of 60 seconds. My layer height is 0.05mm with an exposure time of 4 seconds. The only "cons" is that this resin is not particularly low odor, but you must wear a respirator and nitrile gloves when working with the resin…

ABS-like gray is my color of choice for anything that needs painting. Red makes amazing prints and behaves the same as gray with the settings. However, BLUE is very viscous compared to red and I had to double the height of the support to keep it glassy rather than fusing all the supports together and ruining the underside of the print. It might have been a bad batch situation, but I used almost a whole kilo bottle of blue before I got it working as red. I suspect it has to do with blue being…

I ordered this to print things a little heavier for DnD. I fall prey to broken little sword sticks etc and am frustrated that the painted model is now broken. Heard good things about ABS like Resin and Elegu. I love the regular resin there, but this thing just doesn't "stick". For some reason the models were not treated properly. The situation on the bottle should be treated with caution. I had to increase the shutter speed on my Anycubic Mono SE from 2 seconds to 2.5-3 seconds and with smaller