🖤 Black Enokay Case for Raspberry Pi 2 Model B B+ and Raspberry Pi 3 Model B B+ Review

The case is simple and well made. It was a bit difficult to install the SBC into the case at first, but it was easier the second time around. The second time I had to make changes to the design. The Micro SD card is inserted through a hole that narrows to eject the card. However, I bought this for a Pi3 that doesn't have a push and release for the micro SD card. Because the cone was at the bottom of the card, I couldn't insert my fingernail to catch the edge on the top of the card. So if you…

A few days ago I assembled my last Pi with this case and just before installing the heatsinks I noticed that the bigger heatsink had a band number so apparently I checked it is 9448A, it's just regular tape, you can google it. The correct tape would be 8805, 8015 or other thermal tape. I was shocked because I used some of their covers so I thought ok I would contact the seller for a refund or restock the heatsinks. The answer I got was terrible. They said well you bought our cases three times…

Works great when the card is properly inserted and locked in place. I'll try to be more helpful than most of the other reviews I've looked at to figure out how to put it together properly. Basically you're trying to line up the holes on the circuit board with the holes in the bottom of the case, insert the side with power, HDMI and audio at an odd angle that they fit (the top pieces at least), and snap into place. Don't worry, nothing will break. They just made this case very weird. If you're…

I bought this case for my Pi3. The heatsinks are easy to install. I ended up not needing any of the smaller heatsinks, so I have a spare. The board was a little tricky to get into the case and required a bit of trial and error. You'll know you're doing it right when the HDMI and audio jacks are perfectly matched. If they are misaligned, start over or try something else. Note that once the Pi 3 is seated in the case, pliers are required to remove the micro SD card. I was concerned about how hot…

Works great with Raspberry Pi 3 Model B board. Comes with 3 heatsinks although Pi 3 only needed 2. The case looks very well made and all connections are perfectly matched. The kit even includes a mini screwdriver for assembling the case. A few notes: The case is held in place by 4 screws. This makes the case look very solid, but you have to remove the screws to get into the case. It might not be the best choice if you need to access the board frequently. In this case, the MicroSD card cannot be

After spending more time than I thought going through all the different Pi case options I settled on this one. It comes with heatsinks and screws/screwdriver so you're ready to pop your Pi into it. You may view a case that requires screws as a disadvantage over a case that just snaps open. So keep that in mind if you're sensitive to it. I thought the screws would be easy to insert and easy to remove when needed - I don't expect to have to open and close the case frequently. Overall I am very…