🖨️ ESUN 1.75mm Printer Filament 2.2lbs: Advanced Additive Manufacturing Solution Review

I switched to eSun 2 years ago on the advice of a friend. I was blown away by PLA+, especially the "warm white" color which I felt printed best. When the pandemic hit in March 2020, it became difficult to find thread to buy, so I tried a few different brands. Actually everything I could find. When the eSun filament was finally in stock, I ordered 6 rolls. I was unpleasantly surprised to find that something seemed to have changed. It still prints well but 4 out of 6 rolls keep breaking. The…

I have more than 30 reels Black Thread bought it and it was "used to be" the best. I've printed all my products with it, bought roll by roll, and my printers have adjusted flawlessly to this filament. Unfortunately, something must have happened in their factory where the filament became contaminated. I've attached a photo to show the problem. It looks like moisture, but it isn't. I've had buns in the dehydrator for 5, 10, 25, and 48 hours! with no success in improving print quality. You can see

If you want to constantly deal with clogged nozzles, sticky thermal breaks and constant under-extrusion, this is the filament for you! Oh, what about the entanglement right after the coil? It worked well on some initial test prints, and I felt confident enough to use it for a long 15 hour print. Good finish, good adhesion etc. It stops extruding completely after about 13 hours. Try saving the print with another filament, it won't feed. The nozzle is clogged. Clean the nozzle, try another…