🚘 ESUPPORT Car Red LED Fog Light Rocker Switch 4Pin 12V 35A ON OFF Bright Rear Front, Toggle Switch for Enhanced Visibility Review

Used on a 2004 Tacoma. They don't fit perfectly in the lower center holes of the dash (in front of the switch above the lighter sockets), but they look better than I expected. They're a little smaller than the Toyotas, but unless you shine your light on the dash looking for a slot, they seem pretty standard to me, and I plan on keeping them. The build quality is better than I expected, they are very solid with positive impact. The blue LED is too bright for me as I expected, but I was surprised

As the name suggests this is an almost exact copy of the Swan fog switch in my 93 Pathfinder. The rocker turns on in a different way though, which makes things worse if you want to mix and match with the real ones, but no problem if you're using it alone. I had issues with the indicator light in one of these, but opening and clearing the connections fixed it. The light is brighter than it needs to be, at some point you can add some resistors to deal with it. It took a few minutes to figure out…

I use this to turn on the high beams on my truck. I connect my headlights through a relay so I only need a small amount of current through this switch to start the relay and the relay will send current to the headlights. I used the previous reviewer's schematic and some trial and error. I wanted the indicator to only light up when the light is on. I found I only needed one ground wire, not two. However, another validator may not use a relay. My route with the relay only required a ground at the