💡 6AN Male Flare to 3/8" SAE Quick-Disconnect Female Push-On EFI Fitting in Aluminum with Enhanced SEO Review

Good fit and finish seems to match the fuel filter well and my -6 fits the line. Required to install a Corvette style filter/regulator as a replacement for the LS when converting to an aftermarket fuel rail without a regulator. Works great so far.

I ordered two of these, one fits either side, I needed it but one didn't fit. Changed, same result. I changed it again and lo and behold: it still didn't click like the other one. I ended up using a pipe cutter and trimming the fuel line a bit so it snaps into place. The only reason for this may be the different tolerances for each part supplied. Otherwise, the hardware makes a good impression.

I have both a 3/8" and 5/16" threaded ring that needs to match the collar of the pipe being used. The picture shows a groove but this part is almost identical to the Russell fitting it replicates (Russell 644113). I was hoping to get a grooved part as my application has severe space constraints on the passport side. Spring. The quality looks decent though, it's just not very useful in my case (and the picture is completely wrong).

I have read reports on other sites of this particular quick connector failing, ripping off the engine's fuel rail and burning the car down. I didn't take it too seriously, I mean it's an accident right? NOT CORRECT! I was stranded and needed it, this part was the only one available for next day delivery. This part failed after 30 minutes of driving. The plastic insert absorbs some of the engine heat, softens, and the fitting rips right off the fuel rail, spraying gas everywhere. When cold the…

I took a chance and figured this fitting would fit my existing 1998 Jeep Cherokee AW4 automatic transmission perfectly. It happened! So if you have a 3/8 inch male connector, this end will match the female end perfectly. Of course you must be able to remove the plastic retaining clip from your existing hose/pipe without damaging it in order to use this fitting. so do it very carefully. So if it will fit the pressure fitting on my AW4 oil cooler lines that means it will likely fit most A340e…

I purchased two of these fittings and the design of the fitting allows the use of simple hand tools rather than a special tool to remove the fitting from the GM style fuel line. I think it's great. But the seller's claim that "our products have passed rigorous testing prior to packaging" is simply not true. One of the fittings I received somehow missed a step in the manufacturing process and didn't work. I sent it back for a replacement. Do not lie to me! I understand there is some…