🔍 Enhanced SEO: Fabtech FTS4130-7 3-Inch Spindle Kit for Toyota Tacoma Review

the caliper did not fit on one side and the spindle needed some sharpening but otherwise it runs and looks much better on my 1998 car.

Spindle worked exactly as I hoped. A little change if you're not a good mechanic, but not impossible. The instructions were clear and easy to follow. I definitely recommend it.

Fits 97 Tacoma 5 Lug 2.4L along with Kenda Klever 30" mt. Looks great, has a good forerunner position. Minor trimming of front bumper and rear wheels. Trucks look cool with spindles. Fabtech back shackles will be added in a few days.

Spindles arrived quickly and without damage! Clear installation instructions. The standard brake housing is NOT assembled, but there is only one mounting hole with at least 5-6 screws required for proper installation. Still brainstorming setup ideas! The upper screw of the caliper on the driver's side was difficult to screw in, I had to do some tinkering, but it worked in the end! You will need longer metric forearm screws before you start, the standard screws are too short! Also, it gave my…

I installed a full set of 3 inch spindles on my Taco SR5 2000 5 lug. Multiple problems. Fabtech recommends 30x9.5 tires with 15x7 wheels with a maximum rear spacing of 3.75. After buying and installing on 4 West Covina bikes, the first problem was clearly visible. Spindles are more suited to the off-road Baha style. No spacers are required here. These spindles pushed the BFG AT 30x9.5 out 5 inches on both sides with only 1 inch of fender clearance at the top of the tire. NOT GOOD. After some…