🚗 TOPGRIL Mud Flaps Kit for KIA Sportage 2017-2020: Front and Rear 4-PC Set for Maximum Mud Splash Protection Review

I have a 2020 Kia Sportage and they don't fit me. Holes do not match. Body lines do not match. Did you send me the wrong item? May be. I won't waste my time going back. take it as a loss I need to stop buying Revane junk.

Bought these for a brand new Kia Sportage 2022 and the bend and pre-drilled holes had NO chance of aligning properly. Maybe they sent me the wrong ones. Ordered from another manufacturer and they fit perfectly (and were cheaper)! 3 stars because the return process was EZ!

The valves themselves were good quality and good value, they fitted well and the holes were perfectly aligned. The assembly tool was slightly smaller for the screws. I had a high offset Phillips screwdriver for the rear kit and the rotation of the wheels on the front allowed the use of a regular screwdriver so installation wasn't a problem.

The instructions on the ad and those with the fenders were very incomplete. What they don't tell you is that you have to remove each wheel to be able to remove the bolts, place the valve and bolt it back in to hold it in place. Even with a "short" screwdriver, the wheel prevented access to the screws. Unless you have a complete "tire change station" expect A LOT of work installing these flaps. Now I just have to wait for bad weather to see how they do.

They are NOT designed for the 2018 Sportage. There was a huge gap between product and vehicle no matter how you aligned/switched them on all four. The holes did not match the factory holes. The product came in a box as if it had been used. I wouldn't be surprised if I received a product that someone else would have to return because it doesn't work. Common sense to wear them but obviously there is a big problem with this product.

Easy to install and fits perfectly. I rotated the wheels for a front mount and used a ratchet screwdriver for the rear since it's more difficult to reach. The holes on the fenders match the current bolts on the car. Remove the three screws already in the wheel well holding the fender in place and reinstall them in the same holes. Hold onto the fender to ensure a tight fit. You need to add a screw on the bottom of the fender. Insert the screw into the pre-drilled hole in the fender and tighten…