🔌 Ford OEM 2L5Z-6C324-CA Connector Review

Ford part priced differently than Ford. Fits my 2002 Ford Edge 3.0L snugly. Do yourself a favor and buy upper intake manifold gaskets at the same time. I removed the upper intake plenum, removed the old cracked PCV/hose and quickly installed the new one. This part took care of the lean codes on both banks. About an hour total time.

Factory part at non-factory price! When I removed the intake manifold to replace the gaskets, the old part was soft and cracked from years of oil use. Take care of codes PO171 and PO174 (rely on banks 1 and 2). The top chamber must be removed to install this part. I had to shoot a second time because there was no part included when I replaced the intake gaskets. The exchange lasted about 40 minutes.

I have an optional 2003 Ford Ranger Edge 3.0L 2wd and it was a great part and it fitted perfectly. It was about $20 less than the retailer and I received it in 2 days. Could not be better. This product was God sent as I could only find the part at the retailer. I traveled all over town and went to every auto parts store to find it and nada. The Ford is kind of a pain in the ass in that regard, especially when it comes to these Fords. The bad thing was that the instructions were not sent with…

Construction and fit was as good as factory. Had to replace the old one because it was dry rotting and broke at the end that slides to the top of the PCV valve. Installation is a little tricky as it's not as intuitive as you might think and no instructions are included. If you need advice, you can visit several ranger forums. In short, you have to bend a long thin tube to slide it into the hole where it will be inserted. Don't worry, once you insert the tube into the hole and push it all the…

Purchased for 2003 Ford Ranger Edge 2WD 3.0L V6 Code U This is a genuine Motorcraft OEM part at almost half the price. Replacement parts are possible, but genuine Ford parts have lasted me much longer and I find them more reliable. This part comes with all related parts including suction pipe, elbow, reducer, heater pipe and PCV valve. A few years ago I only replaced the valve itself, but recently I had a CEL popout due to minor smoke escaping from dry rotted rubber parts. This kit is a great…