🔧 6 Pack of Gas Can Spout Gaskets - Replacement Rubber Rings for Fuel Washer Seals and Spout Gasket Sealing Rings - Compatible with Most Gas Can Spouts Review

Like a great price, comes in a nice plastic case that will eventually be reused for other uses. Not sure yet - fits very tight. It takes some force to tighten the cap flange onto the spout. Time will tell about the durability. But for the price I got it was worth it even if they last a year.

I bought these to replace the gas cap/fuel gauge gasket on a round fender (67) on an old John Deere 110. The OEM gasket for replacement units was replaced a year ago with a flat "paper" gasket made from old cork. Fuel spills on the hills. The seal in question is a very flexible, rubbery ring that fits perfectly and completely prevents leakage when the tractor is driven on uneven surfaces. This contemplated gasket or gasket works better than the old cork gaskets and much better than the cheap…

If you mean FR1G501, you can! Your jar comes with a round o-ring that fits into a groove on the dispenser. These are thicker flat o-rings with an internal groove. The lower bottom edge of this o-ring fits into the groove that holds the original o-ring. The o-ring groove fits over the top wall of the dispenser o-ring groove and the top wall of the new o-ring now covers the top surface of the dispenser. When you screw the dispenser back onto the can, you may feel the resistance of the new o-ring…

They appear to be made from neoprene rubber and not nitrile which is 'fuel resistant' but they will swell with prolonged exposure to fuel. Wouldn't it be optimal to have a seal that is rated for fuel, maybe fuel tight? I'm only giving these 2 stars because they are the best pads I could find on Revain, wow it's sad that our standards have dropped to the point where this is considered a good product. As you can see in the attached photo (not the best pic, but it's a pad from the same package…