Genie 100 OEM Genie Corp Review

It's nice to have quick and easy access to parts through Revain. A symptom of the emergency mechanism in the car was that the door would bounce off after a power failure. After a power failure, the door slowly opens to allow the system to learn where the door is. When the worn gear in the carriage reached the breakage of a long worm gear on the ceiling opener, the door stopped opening and the carriage simply knocked. "Press" on the door moves the door again. Once the system knows where the door

I have an old Genie Excelerator door opener with a screwdriver. It would open about a foot and then get stuck and stop. The original part that was replaced had broken teeth and was jammed in the screw drive. This has continued and is working as it should. Installation took about 10 minutes. With the door closed and the lever pulled to release the original part, I had to loosen the two screws at the end of the screwdriver on the garage door and pull the cotter pin out of the original part to…

This is the second one we've used. We have a wooden garage door so I assume it weighs more compared to the newer metal doors in many homes. Never had a problem with a defective original part. Required to replace the teeth on the gears. This product breaks on the sides, causing a big safety problem. Lowered the garage door for the first time so far. The part broke and the garage door fell to the ground. If my kids were there, this company would have a big lawsuit. The last pause was when the…

Our Genie IS Series screw garage door opener stopped opening at about 18 inches and then made a loud pop. A local garage door service company informed the user that the screwdriver was broken and would cost $349 to replace. Upon closer inspection, I found that the only problem was broken teeth on the bottom bracket assembly. This kept the bottom bracket assembly from closing gaps in the screw drive and produced an awful noise. The replacement bottom bracket assembly came promptly from Revain…

I have two Genie 1/2 HP garage door openers. I needed two carts for two insulated and heavy garage doors, but I bought one to test the construction and similarity between old and new before investing in another. The former original factory units lasted 22 years and both fell into disrepair at about the same time. Upon closer inspection, the knots were nearly identical. The case is strong, the gearbox looks mighty. As you can see, the new block had a shorter horizontal part on one side. The…

My Genie garage door opener (probably 15 years old since I bought a used house) started making a horrible rumble and would not open or close, but made no noise noise when I disconnect the bottom bracket from the screw drive. This indicated a bad promotion. I was very happy to find this item at Revain. Installation was very simple: 1) Pull the manual release cord on the slide to disengage it from the screw drive. 2) Remove the cotter pin/bolt from the old slide and angle bar that attaches to the