🔧 Genuine Subaru 803916010 Gasket, 1 Pack for Enhanced SEO Review

What can you say about the poetry? either it works or it doesn't work. This one fits my 2016 Subaru Outback 2.5L drain plug and does not leak

I change them every other oil change or so. good mind FWIW, the flat end of the gasket is against the drain plug. Used on a 2014 Outback 2.5i.

This is a washer that fits my Subaru Impreza. Not available at your local auto parts store, the price (though not ideal) comes with typical Revain speed and makes it easy to change your oil at home.

I bought this in addition to the oil filter for my Subaru. It slides easily over the oil drain plug for a leak-free installation. The goods were well packaged and inexpensive.

Compressible washer is required for the oil drain plug and is used to relieve stress on the oil pan and drain plug threads. When you squeeze the crush washer, the washer takes the load, not the threads. If you reuse a crush disk, compression cannot occur and therefore thread tension will occur. Pay attention to the thickness of the used crush washer compared to the new one. Failure to do so could result in loss of oil, plugs or (in the worst case) engine.

Only four stars as it was just installed / too early to be sure if there are any problems with it but most likely not. Just don't over-tighten the screw or you may lose all sense of putting that gasket on. Price and delivery were good and fast. [Update: I have used the same washer for multiple oil change cycles and can confirm that it has worked well when installed correctly. No drips or leaks/signs of them on the garage floor.]

Own oil and filter), don't forget the drain plug seal! That's the part NOBODY, especially notorious oilers, even thinks about. Because of this, your Sube, which is barely 5 years old, can soil your garage floor. The gasket provides a pressure resistant seal and once you remove the drain plug this gasket will rupture unless you replace the gasket. It is cheap insurance against premature engine failure.