🔧 Efficient Drill Mounting Template for goldenwarm Cabinet Pulls and Drawer Pulls - TM160 Cabinet Handle Drill Mounting Template Review

These handles were an affordable solution for small upgrades that made a big impact in my kitchen and bathroom. Each handle comes with two different length screws and is easy to assemble with a Phillips screwdriver. Highly recommended!

Save money. It's not worth buying. You are limited in placing the handles (vertically) due to the piece of plastic holding them to the top or bottom of the cabinet. I wanted my buttons to line up with the top of the center bar, but that wasn't possible with this template. I regret the purchase

I'm renovating my kitchen from scratch and I needed to mark a spot for three different types of rods. These tools are perfect for that kind of precision. In my case the installation was done by someone else and I just had to make a mark where to put the drill bit and these guides didn't help much in all cases just to make a mark through the holes (too small for the pencil point go beyond the flush). But we did it.

Bought to make a second hole when going from handle to handle on kitchen cabinets, read the instructions (not that I had to do it as these patterns are placed and labeled are, not rocket science ) placed edge to edge of my standard cabinets, nothing out of the ordinary, didn't match the existing handle which was perfectly centered on the cabinet, cabinet handle position is normal, tried both which came, none of them all worked, really po'd because it's ordinary cabinets don't know what imported

This product seems to work for all installations but I have ordered drawer/door handles from Costco and found that the holes The in this one Holes shown in template didn't quite line up with the holes on the handles so I had to approximate and extrapolate them. (This really helped with vertical alignment for drilling on the doors, and the sharp bit provided was very helpful.) As for the horizontal measurement for attaching doorknobs, neither the distance between the two holes nor the horizontal

Works right out of the box, comes with a drill bit great for drilling precise holes in wood. Tips: Place a piece of masking tape over the center drawer. Use a tape measure to find the center of the top of the drawer and mark it on the tape. Center the template on the mark - it will rest on top of the drawer and hang in front of the drawer. Use the template holes to mark the spots that will match your drawer handle. I had Menard's 3" rods and the pre-drilled holes in the template matched…