Graco CleanShot Shut-off Valve | Model 287030 Review

I don't know how I lived without them. I've been drawing for 20 years and I'm not sure how long it's been but I can tell you I've missed it. This eliminates spatter and gives you any angle you want to spray on a surface. The only downside is the weight, but the benefits of this clean shot check valve far outweigh the gun's heaviness. Goodbye stairs! Farewell, leaning at the wrong angle!

Works very well. I stopped using gun extenders a long time ago because of the spitting. Now I just have to get used to using them again. It's a bit awkward with the weight at the end of the tube, but I don't know how else to solve the spitting problem. I suspect it could be fitted to the end of a worn gun and that would eliminate the spitting. It's expensive, but it's Graco and you know it's an American company. at the highest level.

At first I was skeptical about this compressor. I've used many extensions to spray paint inside and out and never got away with spitting. This compressor is a little heavy on the ends of the extensions but completely eliminates spatter from the gun. Leave the fan clean as if you were just spraying with a gun. This handy little tool prevents you from bending over with your back to hit the underside of the side panel and prevents working with stairs. Depending on the extension used, you can also…

I agree with everyone saying how great it is. At the same time, he kicks the extension quite hard when turning 90°. My plan was to hold my shield on an extension in one hand and a spray gun with a 30 inch extension in the other so I could walk around the house painting gutters without a ladder. The only unexpected problem was that it has such explosive power that when it actually fires, it ricochets off the atomizer tip a good 12 inches, so you end up spraying all over the place uncontrollably.

If you want to get the best results from your airless sprayer this is a must have. This valve virtually eliminates gun "spitting". This valve must be properly adjusted to match sprayer pressure to valve shut-off pressure. Combine this with a good tip for the job, the atomization is near flawless. This valve also gives you the ability to rotate (tilt) the spray head slightly. This valve is a bit more expensive but it comes with a RAC X base and tip so the cost is pretty decent. It's made by…