🖨️ Ceramic Cartridge Heating Printer: Efficient and Reliable Grizzled Technology Review

These were ordered for the Ender 5 Plus. It is larger than other machines and requires cables longer than 1 meter that other heaters have when connected directly to the terminals of the controller. Here would be these. Used last night, printed overnight with no problems. Delivery 1 day, must be in local warehouse. Still fits well in the Creality heating block, not too tight and not too loose. Will buy again if needed.

Not bad cartridges for the heater. The outer diameter is 5.75 ± 0.02 mm. I measured the resistance of all 5 as follows: 1. 13.0 ohms2. 13.2 ohms3. 13.6 ohms4. 13.4 ohms5. 14.6 ohms 13.6 ohms average with a standard deviation of 0.6 ohms. At 24V they draw about 1.8A, which is an average of 42.5 watts. I tested one and measured 1.87A at 24V. #5 is slightly different than 39W but still within reasonable limits. The insulator has a wax coating that is sticky to the touch. I really don't like that…

The ones I received weren't. You have 40 watts. They appear to be well made, but one of the five items in this set shows it is open on a continuity test. So only 4 out of 5 are usable. The resistance measurement ranged from 13.5 to 14.1 ohms. This calculates up to 40 watts at 24 volts. I see they updated the product description to show it's 40 watts, but some of the product descriptions below still list 50 watts. They need to be updated. My other big complaint is the smell. After opening the…