🔒 Hydraker 4Pcs Heavy-Duty Stake Pocket Tie Down Set - Ideal for Utility Trailers/Flatbeds with Hitch Pin(4) Review

They say it fits in the pockets of a truck. The product is not suitable for commercial vehicles unless intended for the aftermarket. The product cannot be used with a standard truck platform.

This is what I need to tie round bales. He seems more than strong enough to withstand the strain. Fits in a peg pocket but is very loose. There were issues using the right rear stake pocket as trailer ramps on that side prevented access to the ramp. I had to use a bolt instead of a screw.

Pay close attention to the dimensions (I don't have them), they are significantly smaller than the standard tubular pole bag (see photo) as a result when you attach straps, pulling them at VERY bad angles. They are not fully welded (outside only) and are not aligned so they do not sit flush. Overall I would skip them and build my own.

This is exactly what I wanted. I installed them on a mother of pearl gooseneck pendant and they work great. They're versatile and won't get stuck in peg pockets, so I measured and drilled additional bolt holes that hold these D-rings in place. I plan to order 4 more so I have enough ties. They are rated 12,000# and should hold up my tractor and gear well.

We have a brand new 10 mile equipment flatbed trailer and it had no mooring provisions. We got them so we can protect devices of different sizes. We will also use this trailer to transport pallets of blocks and bricks. These mounts are ideal as we can move them as needed depending on what we are towing. The metal is lighter than I thought based on the rating but I double checked the manufacturer's rating and they work great.