🔧 Upgraded Pump Motor for MTE Hydraulics AMF4633 | IM0024 | 39200428 | 39200428F | 39200513 | 800302 - Rareelectrical Review

The motor was perfect for my power transmission. Installed in minutes, works as advertised. I ordered with 2 day delivery and it arrived as promised. Great overall experience.

What I expected for a good price. Delivery was as planned. The only one who was dissatisfied was my neighbor as the repairs were done in the entrance and not in the shop. Are words enough? Don't make me write a longer review than I think is necessary.

I used this to replace a rusted original hydraulic pump motor on a 2014 American bus. Fits like original. It's working fine so far. It's a little difficult to set up for this mission, but that's not the engine's fault.

No engine problems. Installation was easy, just two screws and wiring. You may have to carefully pry off the old motor. Before installing a new motor, make sure you can turn the pump shaft first! Use the crescent wrench to turn the shaft. My pump turned out to be stuck after I put a new motor in and smoked it out! (literally) Back to the internet for more parts.

Fits perfectly. My 1999 34n Fleetwood Pace Arrow wasn't that hard to get to. However, as a new owner, I found my old one to be fine. It seems that the dealer I bought it from did pre-delivery testing and removed the + jumper between my two home batteries. This left only one battery to run the pump, which would slow down and slow down until the battery died as there was no way for the single battery to recharge. I finally found out after installing a new pump and realizing it didn't work either.