🌡️ Inkbird Temperature Humidity Controller ITC-608T Pre-Wired Dual Stage Thermostat 120VAC 15A 1800W ETL Listed for Mushroom Greenhouse Homebrewing Review

This controller is very easy to set up and use. I use it to control temperature and humidity in a small indoor mushroom greenhouse. Once you've determined the locations for the sensors, it's a device that makes things a lot easier. This allows you to see the current conditions on the display while it controls the on/off operations as programmed. I recommend this product to anyone interested in an automated solution.

So it has no overload protection. If your air conditioner starts too soon, it will fry the module and never restart, creating garbage. Mine ran for one cycle, the compressor had a hard time running the 800w unit, half the unit's control unit. hence it has no overloaded circuit breaker. If your air conditioner starts too soon, it will fry the module and never restart, creating garbage. Mine ran for one cycle, the compressor had a hard time running the 800w unit, half the unit's control unit.

I bought a combined temperature/humidity controller. Very functional and easy to understand flowcharts that can be overwhelming at first. Experiment with it before connecting it to your final application; Place the sensors in different locations (blow a deep, warm breath or blow lightly on the humidity sensor, the relative humidity will rise or fall, similar to holding a temperature sensor or chilling it in ice water). Mess with it, you'll get it. It took me about an hour. It's worth it. I…

I received this thing a little over 2 weeks ago to regulate temperature and humidity for my new crested gecko. it was working fine until last night; At some point the humidity sensor stopped working properly and the fog machine seemed to run all night. I woke up this morning to find that my gecko's entire body was soaked and now I'm late for troubleshooting and also because I had to take out his wood decor and put it in the oven to dry and avoid mold. it was that wet. I bought this because I…

UPDATE. Last spring there were occasional crashes. Now it is not possible to turn on the heating when needed. Its only purpose is to see the displayed temperature. So we need to go into the cold and press the SET button twice, after which the heating will start. The product appears to offer a very limited interval between the temperature at which the heating kicks in and the temperature at which the cooling kicks in. . This could be good for something that requires tight temperature control…

This product does exactly what I wanted it to do. I used a rheostat for temperature control but found I needed more accuracy. My humidifier was on the timer and I needed more precision again. This point applies to both. It includes remote sensors that feel solid and a long power cord that has a reasonable chance of forgoing an additional power strip. Configuration was easy. The display is large, easy to read from a distance and shows both the environment and the operating status of the…

This review is based on an unsolicited email solicitation from Inkbird. have you tried this Does it meet your needs? I tried it and found that it is very lacking. We would appreciate if you could help us answer the following questions. Since this is a new version to improve the products and improve the quality, I am writing this letter to seek your advice. If you have any advice, please reply below.1. Where will you use it? such as greenhouse, aquarium, sausage smoking, brewing? I was planning…