🔩 IVY Classic 2" High Carbon Steel Screwdriver Bit (46218) Review

Pull it out to 3/4 hole depth and remove the shavings, then refine the depth if you need a 7 1/2 hole depth, get the next bit size. I needed a 7.5 and bought a 7.5 but only 7 of these are good for drilling, I had to get the drill out of the chuck as much as possible while it was still stable. It worked, but it would be nice to have the following size

I was looking for drill bits and settled on the Ivy Classic and Wood Owl. I personally thought that a wooden owl would work better in a simple way because it has 3 cutting faces, of which the classic IVY has one. Start as you can see. Also, the IVY hole was easier to drill with my spacer. I made some holes as I was surprised Wood Owl didn't outperform IVY, 3 cutting faces popped up in my mind again. Maybe Wood Owl is better with a drill? Anyway, I like this auger! Both drill bits were 3/4" by 7

I had to 6" deep 13/16 holes drill for my floating shelf bracket and finding the right drill bit has been a challenge. While some are available, they are either very expensive or have a shank size significantly larger than my typical home improvement drill bit. Luckily I found this one. It arrived quickly and was well packaged in a bag that I can use for storage. I pre-drilled each hole with a 3/4" forstner bit to start leveling (I probably didn't need to, but I felt better). Then I put this…