🔧 High-Quality Replacement Carburetor for Ford NAA Jubilee 1953-54 Tractor – EAE9510C Review

Started for the first time and also worked at idle without adjustment! I didn't have any cleat fit issues like the others. 1954 NAA

perfect fit, but runs bold and cannot be adjusted at this point. The tractor is now in the workshop, let's see when the job is done. If all goes well and a simple solution is found, I will adjust the rating.

I didn't know what model my old carburetor was. This made ordering a repair kit impossible. Not only that, I got a completely new, debugged system that just works. Much easier than the option I avoided.

Most Facebook users in the tractor club would say that the selection is poor. I chose this based on the reviews and it wasn't the cheapest. Installation went well and like many other reviews, the float came off easily. I will unsubscribe when the tractor is tested under load.

When I first installed this gasoline only gas came out of the air intake whether the tractor was running or not. The adjustment eyelet for the double float was missing on the inside view. I did everything I could, but now the tractor only runs for a few seconds and then stops.

Matched my 1953 Ford Jubilee tractor perfectly and had everything needed for installation. Just make sure and paste the link correctly. It took me a moment to figure out why pulling the choke knob would cause the engine to rev up. lol! It's still a little early on durability, but the quality seems good.

Have rummaged through all forums. everyone. They call it. I always thought I had a coil or timing problem. Symptoms.always.had.to.adjust.carburetor.gagging.all.time! Then. full tuning.points.auto lites 437s.cap.rotor.same.no change.caruretor arrived! The second best day of my life! A few minor adjustments. !BUT! I actually think I set it right when it was delivered! I just mowed 3 acres of 4 foot tall hard grass! Great tractor. Like new with a new carburetor! I'm at agonz965@yahoo.com if anyone

My old Jubilee stopped working well after two years. Made coils, plugs, wires, points, etc. Eventually gave up and blamed his problems on the carburetor. After reading the reviews I decided on this one. It's not the cheapest deal on Amazon, but not a single reviewer mentioned having to drill holes to mount the carburetor. $15 more, I rolled the dice on this one. I'm glad I did. The carburetor ignited and the tractor started immediately. Of course, I adjusted the mixture screws during operation…