I got it for my entrance door of my apt and was very easy to install, it’s close the gap that is between the door and the frame on the side that have the hinges. Now is no mor hot air coming from outside and isolated perfectly. So far is great adherence and stay in place. I’m very happy

This foam tape was used around the front screen security door of my home that we purchased recently. The hinge side of the door was properly sealed but the rest of of the door; the entire section that swings open/closes was left unsealed. This tape was the perfect solution. It’s easy to work with. It adheres very well and stays in place. But don’t worry, if you need to make adjustments and re-align in order to get the perfect seal, it maintains it’s tackiness.

This foam insulation has good, strong adhesive on the back that holds well once applies but does allow you to remove it and change position when installing. The foam is soft enough to compress and conform to the surface to seal completely.

I used this to line one off these standard plastic cup holders you have in pontoon boats and such. Works perfect for fitting 30 oz and 20 oz yeti type cups. The material is the neoprene type and sticks to cup holder very well.

Probably 80% of the time when I tried to peel the tape off the roll, the top layer would just start peeling off. Not a big deal obviously but just something for others to consider! The one I got from Home Depot was much better

The 3m side rips the product off before you can even use it. Bought 1/4 and is smaller then 1/4. Definitely not worth it as you will destroy half of it trying to peel the 3m backing. Absolute junk just glad it was not to expensive but can’t return as I already started to use it. Don’t buy this crap.

This is poor quality. Disappointed. Can't peel off strip without tearing the foam. Very little adhesive. Won't stick to door jams. Don't waste your money on this.

Foam is dense and one side is very sticky. I snagged a couple of places when installing. The white peel back liner can be hard to get started, but once started peels easy. I will be ordering more.

My windows are more than 20 years old, and the original weather stripping was dry rotted. This peel and stick was the perfect width and thickness, and it was very easy to measure and cut. Product arrived in a timely manner and in excellent condition. I will be ordering more.

I used this for my Milsbo greenhouse cabinets, to help maintain humidity. It sticks really well and is very squishy so it molds to the doors. These work perfect.

Heat rises. So it was important to contain the heat as opposed to letting it escape through big gaps in the lid of my 3D printer (Flashforge Guider 2s). And keeping the heat inside of any 3D printer is important for consistent thermals when printing materials like ABS.

When attempting to peel the liner off the adhesive side the foam split in half and is now completely useless. The adhesive is so stuck to the liner than it ripped the foam rather than release. Ridiculous.There is also no place to contact the seller on this listing.AVOID THIS PRODUCT

I bought these to seal around my mothers living room slideout in her RV. Her's was old and falling off. These were thick and did the job for a whole lot less than the repair shop was going to charge even though its basically the same material they would be using. The foam seal went on easily and the only complaint i have is that the glue could have been a bit more sticky/tacky. I added a small bead of adhesive underneath the foam because i just did not trust that the glue on the foam would…

I lined the holders on a wooden gun rack, as I didn't want wear marks to work into my rifles. It works great and so far is sticking perfectly well. I ran it continuously from top rack to bottom, which it think will work best as it leaves on open ends to start working loose. The material seems sturdy and I expect it to last a long time.

I got this for my college apartment that was surrounded by frats to try to make it a little quieter, and it helped maybe a small amount but I don’t know if it was because of this product or the heavy curtains I put over my windows. However when my lease ended last month I could not for the life of me remove it from my windows. I ended spending hours trying different ways to get it off so I wouldn’t risk losing my security deposit. I ended up using a scrub daddy soaked in rubbing alcohol and…

I bought this weather stripping tape since it was 1/8" thick. The adhesion is very low and the tape easily peels off after applying to the surface. To make matters worse, the roll becomes a jumbled mess since it is not tightly wound like the name brand weather stripping rolls. Disappointing purchase

The adhesive sticks to the paper backing and peels right through the foam. The only method I found to get the paper off is to sacrifice about an inch of foam and for my purposes that is just unacceptable.

Really nothing to say about it does what it says. You know what this is for and yes the adhesive will hold so if this size and thickness is needed go ahead and buy this.

First purchased "Weather Stripping for Doors 2 Rolls 1/2" W X 1/4" T, Black Foam Seal Tape for Sliding Door Jamb, Front Door Frame Windows Insulation, 26 Ft Length (2 X 13 Ft Each)Sold by: YoTache"Loved the stuff then saw this product for a couple bucks less. Received a mass amount of this foam insulation but the quality seems less than my first purchase. Would recommend spending the few extra bucks and getting the better quality product .