KIWI MASTER Harness Pass Through Bezel: Ideal for 2014-2020 Polaris RZR XP 1000 900 S XC General Accessories Review

Easy installation, takes about 15-20 minutes per seat. I wanted the backrest to be flush with the seat, but they still look better than wrapping the seat belts around the top of the seat.

Seats look great. Not too time consuming, just quick learning in the first place and the rest went much faster. Such an affordable upgrade compared to buying new seat belts.

It was from 1/2 hour to 40 minutes for 1 seat. Plastic is difficult to cut without special tools. I used a Dremel tool for one and a heavy duty knife for the other. It wasn't easy, but it worked out well. Take your time.

Installation was easy. In the appearances department, they're fine. But as mentioned by other reviews, the clips are flimsy and fall apart after one ride. I ended up just gluing them together, let's see if that helps?

Very difficult to bury. The clamps holding the two pieces together are too small and any pressure in any direction will cause them to come loose. Because we had to remove so much foam there was not a tight fit around the perimeter and now I worry about what will happen if the seats get wet and the foam is exposed to water. I am very disappointed and regret going this route.

You really need to take the time to cut the vinyl to fit this item. You need to cut a lot less than shown on the picture or diagram. Even if you cut out less than shown, it's still too much. You also need to be careful not to remove too much foam. Take your time. I took my time with my first set and it turned out to be perfect. I got cocky and tried to hurry, the second took too much out of the too big finale and now you can see the gap even after installing it in the passenger seat. I filled…

So the directions are not that good. I understand that using a drill is a reasonable suggestion since most people have drills. But I found something that works much better. Use a Dremel tool to cut out the plastic. I did this on my second seat and it was a lot easier and less messy. I was also able to make cleaner cuts and less fiddling with the foam padding inside. However, it is not easy to avoid removing too much spacer and being able to make a good connection between the two parts. In…

In general, the product is not bad. I have a 2020 Polaris RZR XP 4 1000. After third and fourth place, I found a way to put a plastic grommet in the seat belt. Here are the comments.1. Use a Dremel tool. Luckily I have a Dremel and it worked really well. For the back seat, start with a soft cut, then repeat the next cut deeper until you cut a hole.2. Cutting out the front seat was easy. no questions.2. It's not necessary to remove a lot of foam, in fact the instructions say "not necessary" but…