KYB 343412 Excel G Gas Shock Review

These shock absorbers are fairly easy to fit on my 2008 Mazda 3 hatchback for the rear (you will need struts for the front) and this was the first time I have done this. The movement is noticeably better. Most people who have a jack, a set of metric sockets, a ratchet wrench, and a torque wrench can probably install them themselves without calling a professional. Keep in mind that due to the length of the two bolts securing the bracket, you will need a deep socket to remove the two nuts…

Both stock struts replaced, one burnt out and leaking. Handling, noise and steering are again very reliable. It's a great replacement for the struts and shocks, with a slightly stiffer ride but solid handling with stock springs to keep stock high. All brackets are in perfect position, quality welds and everything is installed to standard specs. Note: Replaced strut mounts (front) and upper mounts (for rear shocks), strut boots/boots and a couple of anti-roll bar bushings to take care of it all…

Replaced 2006 Mazda3 2.0L with these. Great damper set. Very easy to install and no problems at all with the bottom bracket. Just remember to support the axle with a jack and jack it up so the holes match. You probably already raised it when you removed the old damper, so leave it there. You will know when they are aligned because the screw is easier to remove and reinstall. I had no problems installing this shock absorber. A few tips before you go ahead and remove that old shock absorber…

KYB REAR SHOCKS. Bought for Mazda5 2010 with 129,000 miles. There was a problem with the car "shaking" on small bumps on the road. I felt the vibration throughout the car. First I changed the rear anti-roll bars as one of them had a torn boot. More"shake". The next project was the rear shock absorbers. They are easy to remove. I assume that these are the original factory shock absorbers. There are several Mazda3 and Mazda5 removal and installation videos on YouTube. There was no rust on my…