🚗 LIGHTKOREA Gas Pedal Brake Foot Pad Cover Set for Tucson Sonata Palisade Optima Sportage Sorento Stinger Review

This works on Hyundai Santa Fe 2019 in case anyone is interested. It was easy to put on, you may need to soak the brake pedal pad in hot water for 10-12 minutes if it is too hard. Holds up well and looks great!

They gave a great touch to the interior of my new palisade. The goods came quickly, the quality is higher than expected. Easy to install once I put some WD-40 on the brake pedal. The product has exceeded my expectations.

Confirm, fits 2014 Kia Forte Sedan. Fit and finish are good. The brake pedal pad was a bit tricky to put on but that's to be expected as you don't want it to come off easily, on the other hand the accelerator pedal pad was too easy to put on. Time will tell how well they stand up to everyday use.

This product WILL NOT FIT the 2021 Palisade brake pedal. Not even close. Now I wasted my time picking this one and will spend more time returning it. Hello seller, if you want to send me a matching gas pedal for free, I will change my rating of the gas pedal, because it was good.

First I bought them for Hyundai Sonata which Revain says fits my car. The gas pedal fits and gets it to the floor where it should be, not 2 inches. from the ground where he was. The brake pedal could not fit in any way. Lowering the accelerator to the floor really closes the gap between them and takes the pressure off my foot.

This was on a 2020 Sorento. It might not be the best picture due to the lighting, but they look sharp. It was pretty easy to put on. The gas pedal slips from top to bottom, but you have to make an effort to press the brake pedal after removing the factory rubber cover. The brake pedal must go from right to left. Attach the right, top, bottom and left sides. There is a cut-out at the bottom left to make it easier to put on.

Great for my 2019 Hyundai Sonata. The gas pedal simply slides right over the existing pedal. It is necessary to remove the existing rubber pad from the brake pedal and replace it with it. It was difficult to put on, but I envisioned any scraper as a plate scraper, paint can opener, bike tire tool, etc. that had a hard, bent end that would help get the final edge. I used the curved end of a very small wrench to help me. They also suggest throwing it in hot water to soften the rubber, which would

PROS: - easy install - economical - easy to remove - OEM looks - good build quality - haven't had any problems with pedals moving or falling CONS: - Accelerator pedal isn't as tight as I'd like. CONCLUSION: I really liked the look of the sport pedals on the SXL Optimas and originally wanted to just replace the pedals entirely. But I found them and they were much easier and more efficient to install. The brake rests on a rubber ring and simply slips through after removing the old one. The gas…