🔒 Precision Lubrication Made Easy with LockNLube Narrow Needle Dispenser Review

Heavy Duty Grease Needle. Works on its own by screwing into the end of a grease gun or by using the included grease fitting or available grease gun mounts (sold separately). I've used a manual grease gun but should be able to handle higher compression feed systems. Very useful for delivering lube to places where Zerk fittings are not available. Very happy with the quality and durability.

Orange linear guides to make my CNC more rigid. Their bearings are coated with a strange grease I've never seen before. I looked around a bit and found this attachment for my grease gun. I could never get the attached Zerk to work directly in my gun (I don't have a locking end) so I removed the Zerk and inserted the needle directly into my gun. Runs like a champ and now I can grease the bearings!

I didn't like the included grease fitting - it didn't fit tight enough to use successfully. I liked that the grease fitting was unscrewed and then the body and part of the needle were screwed onto the tube of my grease gun so I could insert it into the (tiny) universal joint port and properly lubricate the gimbal. This tool saved my truck's front universal joints and spent about 20 minutes greasing instead of hours and a lot more money replacing those joints.

I've been looking at this lube machine for a while. Finally, after getting so frustrated with running out of lube in those tiny $6 lube cartridges, I just bought this bucket of lube. Now I buy 5 gallon buckets of grease and service multiple units with ease. In addition, the impact of environmental pollution is reduced by at least 1000%. What I also like is that if you only need one grease gun in one machine, you can fill that grease gun faster than changing a cartridge, and again, you don't…