🔌 Lotos CT520D 50 AMP Air Plasma Cutter, 200 AMP Tig Stick MMA ARC Welder Combo 3 in 1 Machine, 1/2 Inch Clean Cut, Brown Review

I have been using this welder for two months now and I really like it. Great car for your money. The plasma cutter leaves some slag on the bottom so I try a different torch. I'll update if I try. Directions seemed good too, I don't know what others were referring to. Even with a different weapon type, still a low-level plasma cutter, it leaves some slag. I switched it back to the original because I like it better. I've had it for five months now and it works great! I use this machine at least…

This is the 2 SEC machine I received from Amazon after ONLY 20 minutes of USE. I REPEAT 20 minutes and the car starts to shit. I AM SO TIRED OF THESE SMOOTHING MACHINES THAT I AM AGAIN WITHOUT PLASMA/TIG WELDING MACHINE FOR ANOTHER WORK NEED WHEN ROLIKK WELDING. ORDER THIS SHIT. I SWEAR TO THE HOLY WELDER HIMSELF THIS MACHINE WILL FUCK YOU. THE INTERIOR IS TRASH, I CAN JUST BUY SOMETHING FROM THE PORT TOUR. AT LEAST I CAN GET IT THE SAME DAY! AMAZON, YOU MUST REMOVE THIS FROM YOUR SHELVES. Oh…

Great car but the warranty sucks. I checked the manufacturer's website, the prices there are ridiculous. They want almost as much as the car costs for an extended warranty. Their consumable prices are also ridiculous. I wish I could wait until the Primweld ct520d is back in stock. Update: I bought this machine in April and it's already broken. I was recently welding. I decided to take a break, so I reached back to turn off the machine. I flipped the switch but it didn't go off. In the end I had

I weld a lot at work, I'm a locksmith. Bought this machine for home use on projects. The SMAW (stick) function works perfectly. I'm used to the hot start feature on most welders, so the feature annoys me when I'm welding in the wrong position, especially on 3/32 rods which tend to stick very easily. The rest of the arc is even and I can place a very good caterpillar. I usually use 7018 and 7024. The plasma cutter works fine. The description on this page says there is a Pilot Ark, but it isn't…

When I ordered this I used Prime in case it doesn't work. I did a lot of research on this before buying and this was basically the only complaint about it. I wasn't spared, mine didn't work, when it arrived I applied for a replacement. It was the Christmas holidays and it took about a week for the replacement to arrive. So I removed the cover and found that the wire going through the top plate had come loose. Soldered cables and everything worked. I suspect that most complaints about human…

I think TIG combo plasma cutter cost is very good but since TIG is my main interest I would have gone for AHP instead must. , which has more functionality on the Tig front, including AC.Observations:0. The ground wire is very short, which is very inconvenient. I need to replace this.1. Doesn't come with a pedal, it will cost you another $1002. Not available with 120 connector (pigtail). From the seller, that's another $353. The TIG torch is decent (WP17) but the hose is not flexible (rather…

Certified mig/tig and stick welder. My honest opinion, from the start I doubted how light the whole car was. Installation instructions for hoses, adapters, torches etc. were not required as everything was carried out clean and dry. So here are my unbiased opinion(s); Cons: I didn't really bother with the 30 amp plug at the end of the whip. I removed that and added a 3 pin 50 amp connector. (Lincoln Plug) No big deal, just didn't fit in my outlets. Second, I didn't like the rear 1/4" mill…