Versatile Lumitronics License Plate Lamp Light: Ideal for Trailers, Boats, Cars, Trucks, RVs! Review

This was a direct replacement for the rear license plate bracket and light on an old Lazy Daze Van. I can't believe how cheap it was. The same manufacturer 30 years later. Great offer.

I installed this license plate light on my old Willys Jeep, it works perfectly. I recently replaced the original bulb that came with the kit with an LED and it works even better.

The lamp did not work, poor contact in the socket. I worked on it for a long time before I understood it. I didn't have time to order another one, so I "threw it out," went to an auto parts store and bought one that worked.

Even though the light isn't LED, it's so crisp for my plate. Lumitronics license plate light with bracket - incl. seal for airtight seal - for trailers, boats, cars, trucks, mobile homes, cars - clear image at night

as advertised, I drilled two 3/16 holes and riveted them to the sheet metal with 3/16x1/2 large flanged aluminum rivets. Usually grounded when I connected the only wire. The light is bright for an incandescent bulb but NOT for an LED.

Nice little light and bright enough. I had to attach it to the surface of the diamond plate on the back of the tablet. I inserted two washers between the light mount and the diamond plate just to make sure the ground is good and it works GREAT right out of the box with no adjustments needed.

What to read. It works, it's decent quality, but the power cord was a bit difficult to get through as the metal frame doesn't have a good place to run unless it comes straight out of the back of the light into the trailer. Frame. Otherwise a good product.

For what I use it's ok. It is used on a cargo trailer. It gets its ground from the frame, but in my case it would be nice if there was a second wire for ground. There's a small hole on the back where the ground wire should be, so you should probably seal the hole with silicone to keep water out.

I had an 18 year old 18ft flatbed trailer and needed a new platform. I watched a youtube video on how to remove an old deck, grab the frame and clean and paint the whole thing. The license plate holder was damaged by someone who "borrowed" it so I decided it was time to replace it. This item was a replica of an 18 year old piece, perfect fit. Great value for money, very good quality.

I used this in a camper van. For this application I needed a ground wire which isn't there. As other reviewers have pointed out, you have to make it yourself. I knew about it beforehand, but it would be even better if it came from the factory. Also, it would be convenient if the equipment for mounting on a plate was included in the kit. A normal product for the price and serves its purpose. listed. Given the points above, this would be ideal.