Magnetic holder Defender CH-129 red Review

I gave it to my parents for the New Year, they are delighted) I like it very much. They put it in RAV4 2022 as in the picture (photo from the Internet)

I use 2 pieces: on Logan 2 and Lancer 10, it is convenient on both machines. Shakes a little on bad roads, not critical. The phone does not fall, although Note 8pro, it is heavy + case, although it has a metal insert. Overall rating 4++.

It holds strongly when the plates are fully assembled. As a proud owner of a polo, I find the attachment point to the ventilation grill to be not very properly done. On other cars, it can be different. I'm worried of breaking the grille when I try to twist the short, wide clamp, and removing the phone a few times ripped the latch out of the grille. In conclusion, the smartphone is perfectly fixed, and the grille is fully attached.

The "clips" on the Volkswagen Polo have a somewhat outsized width. They do not fit completely in all of the slots. I started by making a slit in the middle of the sponges, and then I extended the cut with a needle file (sandpaper) under the internal "blinds" that are butting vertically in the airflow grille. It allows you to sit like a "native"! I would suggest. It's a good thing that the magnet is persistent.

It has strong magnetism and is able to grip the phone; nevertheless, the plate has not been glued but rather placed in a case. There is no danger of the phone being knocked out of its holder at any point.

Nice phone holder. They put it in Lada vesta, sat down securely, did not hang out. The set included 2 magnetic disks, rectangular and round. Put under the phone case without gluing. The phone is firmly held, they flew into pits, ran into bumps, even with sudden braking, the phone did not fall off. So they were satisfied.

Delivery 5 days, the sellers in the store are polite and friendly, they let me open and check the goods. The holder is good on bumps, the phone does not merge, a good company can be taken. The set includes 2 plates round and oval.

The German brand's magnetic holder was similar but snapped. There had to be a successor. Defender appeared to be a good alternative (while the mouse and keyboard were being used, there were no objections). The following problems can be identified when comparing this holder to my previous one: - Never rubberized fastening cups are used to attach the auto deflectors. When removing your phone out of the holder, the grip is quite bad and it may cause scratches. You may therefore easily remove the…

Pros: Convenient holder. There are two clamps for wires in total. Magnets are trustworthy. Below are some downsides: The head's fixation becomes less secure with time and needs to be tightened as a result. However, if this is not done, the thread will eventually break and the mechanism would be rendered useless.

With complete plates, it holds very firmly. The attachment point to the ventilation grill for me, as a happy owner of a polo, is not very well done. It may be different on other vehicles. A short wide clamp, little space for securely fixing the nut, twisting I'm afraid to break the grille, removing the smartphone a couple of times pulled the latch out of the grille. Conclusion: the fixation of the smartphone is excellent, the attachment to the grille is complete .

Has pros: Convenient phone holder. It has a chic appearance. Strong and sturdy housing. The ball joint does not become loose and does not lose its strength; rather, it maintains the position in which it was originally set up. With these drawbacks: It falls off the airflow grill after some period of time, however the problem may be rectified by placing a small piece of electrical tape on it (it is not visible, but the holder is held).

Has some pros: It has a nice appearance, powerful magnets at the base, fits well on the air duct grill, and can hold a smartphone that is 216 grams in weight and has dimensions of 76.4 mm by 165.1 mm by 9.33 mm. Cons: It is difficult to adjust the position of the device, which gives the impression that it was designed for use with lighter-weight cellphones.

Got pros: Doesn't end in disaster Included are not one but two phone cradles. Magnets made of high-quality rubbery material Maintains self-assurance Negatives: The cost of an item has shot through the roof. A gazelle then emerges out the hole that serves as the air vent.

I believed for sure that since my husband uses his phone without a case, it would be magnetized after being in contact with this item. I gave it to him. It would appear that everyone who posts positive reviews on this site purchases separate covers and then adheres a plate to each one. I proposed to my husband that he do this and put it in the car, but he still does not trust the design ( It's doubly a shame since it's cheaper by 25% than what I bought here during the "sale"

Pros below: good product. strong magnets. compact, easy to install and remove, when installing a smartphone does not block the view. Got cons: not all deflectors have ribs for installation that correspond to the width of the slot. backlash

Its pros: Holds well, but only the phone has to be removed from the case. The price is good. Has cons: Since the thing is heavy (magnet), the fan grill is now directed downwards all the time.

a strong magnet magnetizes well BUT, you need to glue the mating part to the phone or case where you need to glue two plates at once, one on top of the other, then there is more metal and magnetization is good. Strong, reliable. The heavy phone holds with a bang! understand how to do it? square and circle (included) stick one on the other! on top of each other and then the magnet is already strong enough. with one plate I fell.

Its pros: Produce has long established itself as a quality product that takes into account the needs of the user. Compactness. Strength. Its cons: The nut that tightens the legs is very large. The paws are not very long, it would be possible to make them 3-4 millimeters longer. Whether it would be more reliable to clamp.

Civic owners know how hard it is to find a phone holder. The front is far away, on the panel the location of the controls is such that they cannot be glued, where there is free space, there are such slopes that not every holder will bend like that, and the deflectors are recessed into the panel. This is the only one that came up, out of four tested holders of different designs

Goods match the description. The mount for the Chevrolet Niva in the air duct is fixed dead, the phone 11 pro holds very well. Prior to this, the mounts were not held and the phone was constantly falling, which led to the chips of the protective glass. This mount does the job perfectly. One minute, it sticks out too much for me, at night when it’s dark in the cabin, I took it down with my hand and the phone was lost under my feet, the seat.